Comentarios de la gente - Escribir un comentario
No encontramos ningún comentario en los lugares habituales.
Otras ediciones - Ver todas
action adopted American amount appears applied approved Association bearing boilers bolts bridge cable carried cent Chairman coal Committee Committee on Standards Company complete conductor consideration considered construction contour contract Contractor cost cover crossings curved head demand desirable diameter drawings duct Easement Electric Electric Railway Engineering equipment flange frogs fuel furnished further gauge girder give given grooved guard inch included increase indicated inspection insulation joint length less limit manufacturers material matter meeting method motion necessary obtained operating period Plain plant possible Power practice present PRESIDENT Hill proposed pulverized RADIUS rails Railway Railway Company recommends referred representing revision screws shown special trackwork specification spirals standard steel stranded submitted switches Table taken thickness tion track tread various wear wheels wire
Página 187 - The materials should be mixed wet enough to produce a concrete of such a consistency as will flow into the forms and about the metal reinforcement, and which, at the same time, can be conveyed from the mixer to the forms without separation of the coarse aggregate from the mortar.
Página 181 - Contractor's Liability Insurance. — The Contractor shall maintain such insurance as will protect him from claims under workmen's compensation acts and from any other claims for damages for personal injury, including death, which may arise from operations under this Contract, whether such operations be by himself or by any subcontractor or anyone directly or indirectly employed by either of them.
Página 176 - IN WITNESS WHEREOF, the said parties have caused these Presents to be properly executed on 'behalf of each; dated the day and year first above written. (Party of the first part) COMPANY, By President. ATTEST : Secretary. (Party of the second part) COMPANY, By President.
Página 210 - ... tests upon two additional samples shall be made, and the average of the three tests shall determine acceptance or rejection of the coil. For wire whose nominal diameter is between listed sizes, the requirements shall be those of the next larger size included in Table I.
Página 172 - Engineer, nor assert that there was any misunderstanding in regard to the nature or amount of work to be done.
Página 179 - The inspection of the work shall not relieve the contractor of any of his obligations to fulfill his contract as herein prescribed, and defective work shall be made good, and unsuitable materials may be rejected, notwithstanding that such work and materials have been previously overlooked by the Engineer and accepted or estimated for payment If the work, or any part thereof, shall be found defective before the final acceptance of the whole work, the contractor shall forthwith make good such defect,...
Página 362 - An analysis to determine the percentages of carbon, manganese, phosphorus and sulphur shall be made by the manufacturer from a test ingot taken during the pouring of each melt, a copy of which shall be given to the purchaser or his representative.
Página 175 - All work that may be called for in the specifications and not shown on the plans, or shown on the plans and not called for in the specifications, shall be executed and furnished by the Contractor as if described in both these ways; and should any work or material be required which is not denoted...
Página 182 - Contractor shall be entitled to the full amount of the estimate for the work done by him under this contract up to the time of such annulment, including the retained percentage. The Contractor shall be reimbursed by the Company for such expenditures as in the judgment of the Chief Engineer...